Garage door opener bracket – First, measure the height of the top of the garage door with a tape measure. Measure from the bottom of the bracket to the top, marlking measurement of the door section at the top of the bracket. Second cut the door bracket if necessary with a hacksaw. File the top edge of the console with a file to smooth over the cut edge. Cut a four foot piece of pre-punch angle iron with a hacksaw.
Third steps to garage door opener bracket, remove hexagonal screws that attach the top of the center hinge to the upper part with a socket wrench. Fourth, place door opener mount over the center of the top door section with the lower holes in the bracket with the top fixing holes in the hitch. Mark the end of mounting holes on each of the bracket to the door with a pen.
12 Photos Gallery of: Make Garage Door Opener Bracket Clopay
Fifth, drill holes for the mounting studs on the top of the door section with a 1/4-inch drill. Shoot before the punch angle over the top of the bracket, line up the two end mounting holes and mounting bracket. Insert a 1/4-inch bolt through the top mounting hole opener bracket. Insert the bolt from behind. Secure the bolt with a washer and lock nut. Sixth insert the screws through both ends of the pre-punch and the bottom of the upper mounting bracket opener. Place the bolts through the back of the frame joint by the lower opener bracket. Tighten all bolts fastening nuts with a wrench. Install door opener bracket under his arm as directed by your garage door opener bracket.